An Introduction To Electrical Wiring

Electrical systems vary widely given their different uses. That being said, the basics of wiring something are not that hard to understand.

Wiring is the insulated conductor that carries electricity. The wire that is used in a building such as a home or a factory is called building wire. The wire inside a piece of machinery is usually called equipment wire. Wire is measured by its diameter. This measurement is known as the wire gauge. Wire gauge runs in reverse numerical order. In other words, the higher the gauge number, the smaller the wire diameter.

Electrical wiring is governed by strict codes. Electrical codes began in the 1880’s at the same time the first extensive wiring was being done. In 1897, the National Fire Protection Association established the National Electric Code (NEC). The National Fire Protection Association was a group of Insurance companies that were concerned about the potential danger inherent in faulty electrical wiring. They had cause for concern. Early wire was bare or covered with cloth. There was little understanding of the need for insulation.

The NEC is used in conjunction with local, country, and State codes that strictly control electrical wiring. The codes are concerned with proper size of wire and with insulation. Factors that are considered are the expected load, the frequency of modifications, and the nature of the environment where the wire is used. Homes have small loads, infrequent modifications and a very non-corrosive environment. Commercial establishments are usually in the middle. The load demands are sometimes higher, and modifications are not infrequent. The factory or industrial site has a very high demand. Modifications are frequent, and the environment is often highly unstable.

Materials used in wire have varied over the years. Copper has always been the first choice because it is such a good conductor and is very flexible. In the 1960 to 1970’s, aluminum wire became popular due to the rising cost of copper. Insulation was usually rubber although rubber tended to corrode due to exposure to moisture and air. PVC compounds are now used most commonly as wire insulation. Insulation is made in different colors to identify wiring circuits in a system.

Electrical wiring has given rise to various connectors. The place where a wire is joined to another wire or attaches to a device is the point where there is the most danger of a spark. It is important that connections are secure. Insulated plastic wire nuts are used to attach two wires. There are also special tools used by electricians to deal with the installation of wiring. An example is the combination wire cutter and stripper. The stripper is used to remove the insulation from the end of the wire so that the bare wire might be attached.

Find an electrician at ElectricianCompanies.com.

Article Source: http://EzineArticles.com/?expert=Donny_Tee

If you are looking for a electrician or need electrical services, please call us today at 866.667.4625 or complete our online request form.